Cisco Support Community
Community Member

2811 Router Caller ID issue

Dear all,

We configured TCL AA on to the 2811 router and registered the GW in call manager as H323 GW. We have telephone lines connected to FXO ports of the router. We recieve the call from PSTN and auto attendant is played from router and can make call to the extns of the call manager. Issue is we are not getting the caller ID, instead we are getting 4999 displayed on ip phone extns. Any config to enable caller ID from PSTN?


Find the config of the rut:

service jazirah flash://its-CISCO.
param operator 1225
paramspace english language en
paramspace english index 0
paramspace english location flash://
paramspace english prefix en
param aa-pilot 4999


dial-peer voice 4999 voip

service nicknetaa

destination-pattern 4999

session target ipv4:
incoming called-number 4999
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad


voice-port 0/0/0
 supervisory disconnect dualtone mid-call
 cptone SA
 timeouts call-disconnect 1
 timeouts wait-release 2
 timing hookflash-out 50
 connection plar opx 4999
 caller-id enable


dial-peer voice 1000 voip
 destination-pattern ....
 session target ipv4:
 dtmf-relay h245-alphanumeric
 codec g711ulaw
 no vad



Thanks & Regards,

M.Mohamed Raffiudeen...


Do you get the Caller-ID okay

Do you get the Caller-ID okay if you just bypass the script?

Cisco Employee

Hello , Can you please make

Hello ,


Can you please make some test call and collect below debugs

Debug vpm signal

Debug vtsp all



Nadeem ahmed

Br, Nadeem Please rate all useful post.
CreatePlease to create content