Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2811 router configuration for SIP fall back when CCM4.1 down

Hi,

I have a 2811 router with 2 E1 Pri and connected to a 4.1 CCM.

My understanding is that the link between CCM and the PRI is direct through the binding below

interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

isdn bind-l3 ccm-manager

isdn bchan-number-order ascending

no cdp enable

thus I have the feeling that the following is useless :

dial-peer voice 1 pots

service mgcpapp

direct-inward-dial

port 0/0/0:15

forward-digits all

BUT, in case the MGCP link with ccm is lost, I would like all incoming calls on E1 be forwarded to a SIP trunk

directly attached to the 2811 (and not to the CCM).

is this possible ?

thank you.

1 REPLY
Green

2811 router configuration for SIP fall back when CCM4.1 down

Hi,

Normal working.

CUCM ----MGCP----2811--E1

For the E1 pri the dial peers are ignored under MGCP
All call control is backhauled to CUCM vis MGCP

Fall back when MGCP fails.

E1---2811---SIP

You loose the MGCP backhaul and call control is handed back to the dial peers.


You need to add


!
!
application
global
service alternate Default
!
!
!
!
dial-peer voice 1 pots
description *** FOR INCOMING CALL MATCHING ***
incoming called-number .
direct-inward-dial
port 0/0/0:15
!
!
!
!
dial-peer voice 11 voip
description *** SIP FALLBACK DIAL PEER ***
preference 1
destination-pattern 81....
incoming called-number .
voice-class codec 1
session protocol sipv2
session target ipv4:10.182.182.12
dtmf-relay sip-notify rtp-nte
ip qos dscp ef media
ip qos dscp cs3 sig
no vad
!
!

You will need to change this use your numbering scheme.
I dont know you need voice translations etc to change the numbers.
Mine shows that incoming call would be for 6 digits starting 81

HTH
Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.
235
Views
0
Helpful
1
Replies
CreatePlease login to create content