Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2811

Hi

i have 2811 with PVDM2-16 and 4 ports FXO, so each port will take a channel from PVDM2-16, the remaining is PVDM2-12, I want to do HW conference resource using these PVDM2-12, is it possible to do this, since I get that not enough DSP resources when trying to create conf profile?

is it a limitation so that i can not share between termination for fxo ports and conf resource in the same PVDM2-xx module? or something else?

appreciate kind helps?

thanks

8 REPLIES
New Member

Re: 2811

You will need a separate DSP for that, since the conferencing cannot share DSPs.

Dragi

New Member

Re: 2811

thanks Dragi for ur response

so i will have PVDM2-12 channels not used !

then if i have 2 PVDM2-8 modules, and I want fxo 4 ports to consume PVDM2-4 from module 1, then i thnk i can make conf resource from the second PVDM2-8 module? right?

Re: 2811

Hi,

PVDMs have different DSP counts. PVDM2-16 has one DSP, PVDM2-32 has 2 DSPs and so on. If you wan to do hardware conferencing with DSPs you must dedicate at least one DSP for that (note the difference between a DSP and a PVDM!) or more depending the number of conferences you need to support.

In your case you should put the PVDM2-8 on PVDM slot 0 so it will be used by the FXO ports and the PVDM2-16 on slot 1 (these slots are on the PCB of the router).

The lowest PVDM I recommend you to use for conferencing is PVDM2-16 since PVDM2-8 is a low cost one DSP module and is not fully functional as the PVDM2-16.

BR,

Stoyan

New Member

Re: 2811

thanks Stoyan for ur really helpful answer,

but note that i have just only pvdm2-16 card being put in slot0, then i got from ur answer it is not possible to do conf using hw resource (conf profile) with this same pvdm2-16 card keeping in mind that fxo will use 4 channels?

Re: 2811

That's right. You will need an additional DSP based on the requirements for conferencing you have.

Check this link

http://cisco.com/en/US/partner/products/ps6441/products_configuration_guide_chapter09186a0080541bf3.html

BR,

Stoyan

New Member

Re: 2811

thanks sstoitsev

is this same case valid for HW conference resource for MoH or not?

i mean i want to utilize the existing pvdm2-16 as HW dsp resource fro MoH can i accomplish this? how?

or is it needed to have a seperate PVDM2-xx also?

thanks again

appreciate ur help

Re: 2811

Here is a doc about that

"Cisco CallManager and Cisco IOS Interoperability Guide"

http://cisco.com/en/US/partner/products/ps6441/products_configuration_guide_book09186a0080541ac8.html

Although I can't quite understand what exactly you're trying to achieve. MoH can be streamed with 711 and 729 codecs and this is configured from the service parameters.

New Member

Re: 2811

MoH needs either HW resources or SW resources, what i meant is that i have 2811 with pvdm2-16 and 4 ports fxo, can i utilize this pvdm2-16 module for both fxo termination and as HW resource for MoH?

245
Views
0
Helpful
8
Replies
CreatePlease to create content