i want to connect 5 E1 PRI's on two 2821 voice gateways, i ordered:
two VWIC2-2MFT-E1 cards
one VWIC2-1MFT-E1 card
enough PVDM2 cards on both voice gateways
i will connect 3 E1's to one voice gateway and 2 E1's to the other voice gateway.
my question is what about voice gateways performance will be ... ok 2821 has 4 slots (can be used for VWIC) and has 3 slots for PVDM2's .... but how 2821 will perform ... is my design described above ok?
do i need to upgrade to a higher voice gateways (2851, 38xx)
is there a capacity tool that measures the performance for voice gateways to build a correct design for such cases?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...