Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2900 ISR compatibility CUCM 6.X

Does anyone have a doc on comptability matrix for the 2900 routers?  We are starting to order these for our remote sites, but we are sitting at 6.1.3.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 2900 ISR compatibility CUCM 6.X

Looks a minimum of 6.1.5 is required for the 2900 series.

http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet0900aecd8057f2e0.pdf

Hope this helps.

Brandon

3 REPLIES

Re: 2900 ISR compatibility CUCM 6.X

If you are looking to run MGCP on the 2900 ISR, I think you may be out of luck.  My 6.1.4 doesn' t recoginize a 2900 series type for MGCP.  It will probably be available in a patch sooner or later, but I don't know when.

However, if you want to run H.323, you should be fine.  CUCM doesn't care what hardware is running the gateway if it's using the H.323 protocol.

Chris

Re: 2900 ISR compatibility CUCM 6.X

Looks a minimum of 6.1.5 is required for the 2900 series.

http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet0900aecd8057f2e0.pdf

Hope this helps.

Brandon

New Member

Re: 2900 ISR compatibility CUCM 6.X

Thanks, yeah, looks like 6.1.5 is going to be my route.  It was just released a week ago or so, so I will be

holding off for a bit.

Thanks again

648
Views
0
Helpful
3
Replies