Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2911 router cme

Hi

how to configure e1 lines for 2911 router and incoming and out going dial-peer

2 REPLIES
Cisco Employee

2911 router cme

There are plenty examples on how to configure E1s on CSC, you just need to do some search, for DPs, if you search dial peer configuration on CCO, you'll find all the related documentation.

If you're also going to configure CME, there's the CME configuration guide on CCO which contains all you need.

Have you reviewed any of those???

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

2911 router cme

Good luck!

controller E1 0/0/0

framing NO-CRC4

pri-group timeslots 1-31 service mgcp

interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

no cdp enable

!

voice-port 0/0/0:15

!

dial-peer voice 1 pots

translation-profile incoming frm-pstn

incoming called-number .

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 9 pots

translation-profile outgoing to-pstn

destination-pattern 9T

port 0/0/0:15

Thank You

Sarawut Sampaothong

124
Views
0
Helpful
2
Replies
CreatePlease to create content