Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2x 7920s. 1 OK, the other "No AP found"

Anybody that can point me in the right direction would be greatly appreciated.

I have a working CME infrastructure w/Exchange, with 99% of the IP phones being 7960s.

I recently acquired 2x 7920s and have configured them both to work with the wireless access point in the office.

  1 unit works flawlessly.  And I am able to place, receive phone calls, etc.

The other, not so much.  Even after using 100% identical configurations on the device, and cloning a good working copy of the 7920 that is functional, one of the devices says "No AP found" and does not connect to anything.

The WAP in question is a Linksys Wireless N (a/b/g compatable).

I'm not sure why one would work while the other wouldn't using the same settings.  Would you guys happen to have any troubleshooting steps I could take on these?

As always, thanks.

Everyone's tags (3)
206
Views
0
Helpful
0
Replies