Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3 Sites using 3 UC500

Hi guys I was wondering if there's a way or it's possible to install 3 different sites on different locations each one with a UC500 16 Users, and share extensions and be able to communicate with other sites, if it is, can you help me with some guidelines and best practices?

Regards

1 REPLY

Re: 3 Sites using 3 UC500

Yes, you can do this.

What you will end up with is dial peers pointing towards the other sites.

If you have 3 sites, say A has extensions 1.., B has 2.., and C has 3..

You would have dial peers on each site that point those extensions to the other ones via SIP or H323.

Site A:

dial-peer voice X voip

destination-pattern 2..

session target ipv4:

dial-peer voice X voip

destination-pattern 3..

session target ipv4:

Site B:

dial-peer voice X voip

destination-pattern 1..

session target ipv4:

dial-peer voice X voip

destination-pattern 3..

session target ipv4:

...etc

You would in essence, create a fully meshed H323 or SIP trunk between each site.

117
Views
0
Helpful
1
Replies