Hope someone could help me. I have a problem with the sip client and CUCME. Teleworker has vpn connection to HQ, throw that connection he need to use SIP client (XLite) to use corporate telephony. All is working fine, but every incoming or outgoing call goes only 30 sec (PSTN) and 18 sec (GSM) and then drops.
I have made debug of ccsip messages and there are no ACK message after 200 OK. So it is sending 200 OK messages, but didn't recieve any ACK, after that connection is dropping. RTP is going well, so I can talk to the remote destination for 30 seconds.
When we tested this in the lab, we had 15.1 IOS version and the same problem. We found the solution in connection-reuse command, but it was introduced only in 15.1 version, and we have 12.4
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...