I saw this error when working on an issue recently ENv: CM PUB,SUB,UCCX PUB & SUB at HQ site, phone at remote site with contact center ( extension mobility and local gw for PSTN calls ) due to wan outage/issue remote phones/CSD/CAD lost connectivity to servers. when servers became available most agents were able to login to EM and CAD but supervisor software was showing status as 32759 device out of service. To fix we had to do following temp solution unassociate/associate phone devices to rmjtapi application user in CM. This is not permanant fix since the real issue is data synchronization between CM and UCCX. perm solution reboot CM and UCCX server cluster another small issue that creeped was PSTN calls on UCCX pilot was not matching correct route point , when calling internally calls were routing fine. This got fixed after restarting MGCP process or reloading router.
I have seen this condition previously before a few times. Looks like the CTI Manager was not able to report properly the status of the IP Phone to the JTapi application.
Usually taken the terminal out of the provider domain and assign it back, causes CTI Manager to notify about the phone added to the domain to the Jtapi application, and the application will be able to monitor the device afterwards.
As well destroying completely the provider with a CTI Manager, or UCCE restart does the same efect.
I don't know of any software caveat for this, although I have run across this condition previously.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...