Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

3800 ISR integration with Bogen T100 paging

Looking for any info on integration between a 3800 ISR and a bogen overhead paging amplifer/system.  I would assume the standard vwic2-fxs card would be sufficient, but I have read that there is an extended loop (vic2-2fxs-e/did)  version with higher ringing current  of this and wonder if it would be beneficial to get this card.

any help is appreciated.

thanks

4 REPLIES
Hall of Fame Super Silver

3800 ISR integration with Bogen T100 paging

I am not familiar with T100, is this a paging adapter or paging amplifier, zone controller?

With paging adapter, i.e. TAMB2 you  can use either FXO (trunk) or FXS (station) connection and both work very well.

Chris

3800 ISR integration with Bogen T100 paging

Yes, use Bogen TAMB between FXS and T100.  FXO can work too, but then you need to add -24V power supply for TAMB.  With FXS power supply is not needed.

-- please remember to rate and mark answered helpful posts --
New Member

3800 ISR integration with Bogen T100 paging

Thanks, all, for the responses.  I am told now that i am connecting to a Bogen C60B amplifier.  Im assuming a fxs to a Bogen TAMB is still the way to go?

New Member

3800 ISR integration with Bogen T100 paging

just an FYI, I got this working with FX0--->Bogen UTI1 Adapter-----> Bogen C60B

Thanks for  all the suggestions

485
Views
5
Helpful
4
Replies
CreatePlease to create content