Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

3845 configured with MGCP together with SCCP for transcoding possible?

Hi all,

We have a 3845 as mgcp voice gateway registered on ccm 5. Due to a remote branch with limited bandwidth, we are in need to use a g729 and a transcoder.

Is it possible to have MGCP configured on the router while using SCCP to do the transcoding at the same time in one box.

since 3845, have PVDM2-64. Have also NM-HD-2V with some DSP.

setup as follows:

ccm5---|

|----------FR-----remote ip phone

3845---|

There is no voice gateway on the remote site. The 3845 voice gateway(used only for pstn fxos') on the branch site is also the not the one connecting the remote and the branch network but a different router.

thanks in adv.

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: 3845 configured with MGCP together with SCCP for transcoding

Yes, this is possible and would work. Depending on how the PVDM's are currently being used. You might have to remove the transcoder configuration from the router incase all the PVDM is currently being used for XCODE and add MGCP Gateway and then use the remaining PVDMs to work as a XOCDE.

Hope that helps

2 REPLIES
Gold

Re: 3845 configured with MGCP together with SCCP for transcoding

Yes, this is possible and would work. Depending on how the PVDM's are currently being used. You might have to remove the transcoder configuration from the router incase all the PVDM is currently being used for XCODE and add MGCP Gateway and then use the remaining PVDMs to work as a XOCDE.

Hope that helps

New Member

Re: 3845 configured with MGCP together with SCCP for transcoding

Hi Mahesh,

Thanks. Great to know it would work. very helpful indeed!

170
Views
0
Helpful
2
Replies
CreatePlease to create content