I saw online that the HP Proliant DL380 G4 was supported as a 3rd party server to install CM 8.6 on. I ran the installation CD and it says the hardware is not supported. Can anyone point me to a link that shows the exact specs for the HP servers? (and yes I have looked myself)
Thanks. I had seen that link. It lists the HP Proliant DL380 G4 as good all the way up to CM 8.6. All the other listings specify either Hard Drive size or CPU speed EXCEPT the DL380 G4. It just says HP DL380-G4 and nothing else. Any ideas?
If you open the following link and search for hp dl380-g4 and then move to the CUCM 8.6 column, it shows number B5. Then if you move to the bottom of the page, it states that this server is supported for "bridged upgrade" only to migrate to a new hardware. So, this server should be out of production when you upgrade it. Having said that, the installation of 8.6 should not give error. Can you post the output of show hardware and the install logs from RTMT tool?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.