Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

4.1(3) to 7.1 upgrade?

Hi there I have ran the DMA upgrade tool for CUCM 7.1(3), this resulting tarball has been used to build the new 7.1(3a) server.

Problem I now have is phones are just sitting in 'opening 10.10.10.1' mode after doing their firmware upgrade.

I have not applied any license files yet, but was not expecting this behaviour, any ideas please.

This server has been built as a test.

Rich

  • IP Telephony
2 REPLIES
Super Bronze

Re: 4.1(3) to 7.1 upgrade?

Hi

Have you verified the CCM service is running? go to serverip/ccmservice, log in and then go to Control Centre/Feature Services.


Regards

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Cisco Employee

Re: 4.1(3) to 7.1 upgrade?

http://ip_of_your_server

Once you get to CCMAdmin click on the top-right menu and go to serviceability.

Log in, check the status of the services.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
198
Views
0
Helpful
2
Replies
This widget could not be displayed.