Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4.1 CME conferencing and DSP's

If I have say 2 PVDM2-16's in a 2811, or even say a PVDM2-16 and a PVDM2-8, how do I determine which PVDM is tied to conferencing and which is tied to terminating voice calls on my PRI?

I've read over quite a few of the DSP farm docs relating to hardware comferencing with 4.1 CME, but still am unclear how the actual allocation of the DSP resources is done. If someone has time to clear this up for me that would be great!

Thanks!

1 REPLY
New Member

Re: 4.1 CME conferencing and DSP's

Check:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddfffc7/0#selected_message

It is a largely discussed theme, sometimes obscure. If you want a good starter information source, try the GWGK course student guide. It has a good starting DSPFarm guide.

Hope it helps,

Met

103
Views
0
Helpful
1
Replies