I have a xlation profile which changes inbound did's from 0XXX to 1XXX. currently,these are cisco phones. I need to then have these forwarded out an attached QSIG PRI to a dialogix pbx to desktop OCS clients. Not sure how to forward out qsig pri, since endpoints will no longer be cisco. any help is appreciated.
just configure a route pattern to match 1XXX and route them to the QSIG PRI you have configured, once you delete the phones when the xlation pattern takes effect the only match will be the route pattern and will make calls go to the PBX or whatever you have at the other end
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...