Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

4507R LLQ????

We have just install 10MB layer 3 circuit between two 4507R at two different building.

There is no priority commnad under policy-map...

My question is that,

1. Can I upgrade to different verison of image at 4506R to fix the problem??

2. If not.. coz i look up the command for 4507R, there is no priority command.. so what do I do?? Is there another way to do LLQ at 4507R?

3. Move 10MB to router??

Thanks

Ken

1 REPLY
Bronze

Re: 4507R LLQ????

Switches are slightly different. You need to check out http://www.cisco.com/en/US/products/hw/switches/ps4324/products_configuration_guide_chapter09186a008073141d.html and look at how tx-queue 3 is used. Voice traffic should be placed there to insure that you're forwarding it via the strict priority queue. You'll assign your bandwidth in the priority queue under the tx-queue configuration like you used to do priority on your routers.

-- -Mark Turpin
108
Views
0
Helpful
1
Replies