I just upgraded from 4.2.3 to 6.1.1. The upgrade went fine. After looking in RTMT I noticed that my replication was broken on two of my subs. I'm getting 4's on my replication status on these subs. I have run a couple of the utils dbreplication commands from the CLI and they have not helped. I ran a repair and a reset. If anybody has some good docs on the replication for 6.X or can offer any help I would appreciate it. Thanks
I do not know if it is in 6.1.1, but in 6.1.2 I was facing a similar problem that is a known bug (don't have the bug number). But stopping and starting the Call Manager service resolved the problem. It is supposed to be fixed in ES 6.1(2.1101.2).
The way we came across it was CFWDALL did not work when using CCMAdmin or CCMUser for external calls.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...