When a call comes in on 890204, it is set to broadcast all phones, then roll to general voicemail box, 890204 which is set up in CUE on site.
What is needed:
Calls hit pilot, when no answer or busy go to voicemail, which is the same number as the pilot?
Is this possible?
What needs to be done to get this to work?
CUCM 6.1 at HQ
2851 in SRST at Remote location with PRI for voice and Full T1 for WAN, running DMVPN - EIGRP
Been beating my head against a wall for 4 hours trying to get this to work the way it is suppose to!!! Able to use the Call Forward option to send the calls to another destination in the Pilot section, is this where I should be doing this at?
For some reason I did this earlier in the night and it did not work. Had a fellow CCIE on the phone from Cisco...Amazing guy...and he told me to do a few things, which is what I did earlier and much to my amazement it worked!
Here is it:
In the Hunt Forward Setting, under Hunt Pilot send the call to the VoiceMail CTI Route Point, then make sure you add the correct CSS that has access to the CTI Route Point and there you go!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.