We are in the middle of a CUCM deployment and on the 6500 I need to set a DSCP or COS value on egress for the CUCM servers. So far I have not found the correct way to set the DSCP. I have attempted to create a service policy and apply it to the physical ports (and I tried the etherchannel just for kicks) and I get the following error:
Policy can not be installed because interface GigabitEthernet2/12 is a member of Port-channel
MQC features are not supported for this interface
How do I correctly set the DSCP value to EF on egress on these ports or the port-channel?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...