Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6921 Phones and VLANs

I had an issue with 6921 phones not staying in the correct VLAN.

Here's the sample config:

interface f0/1

switch access vlan 50

sw voice vlan 900

sw mode access

The configuration initially worked.  I was resetting and rebooting the phones and switches several times.  Then 80% of my phones would not re-register after a reset.  It seems that the phones were getting an IP address in the access VLAN range.   The only workaround was to remove the switch access vlan 50 configuration and let the phone register.  After that the access VLAN 50 configuration was added, and the phones have always booted in the voice VLAN.

Has anybody else experience this issue?  Has it been resolved?

1 REPLY
Cisco Employee

Re: 6921 Phones and VLANs

506
Views
0
Helpful
1
Replies