Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7906G DOES'NT START

I have CCME 4.1 with 7906G Phones (over WAN)

7906G firmware is jar11sccp.8-0-2-25.sbn

After power loss 7906 does'nt start

saying;

"downloading term06.default"

I cannot access the telephone anymore.

1 REPLY

Re: 7906G DOES'NT START

Factory reset the phone and see if it fixes it. Possibly the firmware is corrupted and needs a reload. This will do it

You do this by holding down the # key while the phone is powering up. The screen will prompt you with a message that the reset sequence has started. At that point you hit the following key sequence 123456789*0# The phone will then prompt if you want the network configuration saved choose no.

That will allow your system to recognize the phone from scratch.

105
Views
4
Helpful
1
Replies