I have a site running 4.1(3)es16 and they just purchased a few 7911's. I've uploaded the files (9.0.3) to the TFTP directory but I get nothing. From what I've read these phones should work on this version of CCM, do I need an older phone load?
It looks like I can't go to 8.x.x without going to 7.x.x first, I'll try 7.2.3
Do I need to run the .exe or can I just use the .zip and copy the firmware files into the TFTP directory? I know that version 4.x can be very tricky and I don't have much experience with it, running that .exe makes me nervous as I don't want to break something else.
When you run the .exe the load files will be automatically placed in your TFTP directory and the device defaults page will be updated to the load installed. If you upgraded twice using the .exe file, the second installed load would be the one specified.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...