Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7911G will not register

We have recently upgraded to CUCM 8.5 and several of our 7911G failed to to register. I have tried factory reset but they just cycle throgh rebooting.

It has only affected a few, others have registered and are working fine. Any ideas

3 REPLIES

Re: 7911G will not register

Couple of things to check.

1. Check for the number of licence DLU's available(Device License Units) in CUCM.

2. Also check the configurations for these phones are intact, if not you need to re-register them once again (auto register or manual registration).

3. Is DHCP enabled?

4. Alternate TFTP set?

5. Did you delete the security files and try once.

Hope it helps.

Anand

New Member

7911G will not register

DLU's ok

DHCP enabled

Alternate TFTP set

Phones worked fine prior to upgrade.

I have deleted them from CUCM to force new registration

Other phones work fine

Have tried 1234567890*#  just cycles through Cisco logo and load screen

Have tried 3491672850*#  blanks screen intermittent attempted reload

cannot delete unlock security as phone doesn't load

Blue

7911G will not register

HI

See if below link helps.

https://supportforums.cisco.com/docs/DOC-15799

regards

Ronak Patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
370
Views
0
Helpful
3
Replies