Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7914 Monitor

Hi Guys,

CCME 4.1

!

voice-port 0/1/0

description FXS

!

dial-peer voice 401 pots

destination-pattern 7677

port 0/1/0

!

I want to monitor the number 7677 on the addon 7914. Is this possbile?

Thank you!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: 7914 Monitor

Hi,

Actually you have to configure all things as per "FXS SCCP feature mode" document. I suggest you use a looback interface as "endpoint address" for this.

Thanks for the nice rating and good luck!

Hope this helps, please rate pots if it does!

7 REPLIES
Hall of Fame Super Gold

Re: 7914 Monitor

Hi Ken,

yes there is a method, configure the FXS port as an ephone:

http://cisco.com/en/US/products/ps6706/products_feature_guide09186a00806cab75.html

you will have all the ephone feature on the analog phone, and the ability of monitoring it. This is oly supported on ISR's however.

Hope this helps, please rate post if it does!

New Member

Re: 7914 Monitor

Thank you! I take it I would have to configure like...

!

voice-port 0/1/0

description FXS

!

dial-peer voice 401 pots

destination-pattern 7677

port 0/1/0

!

ephone-dn 5

number 7677

label 7677

description Analog Polycom

name Boardroom

ephone 1

mac-address 0000.0000.0001

username "reception" password 123456

type 7961 addon 1 7914

button 7m5

Hall of Fame Super Gold

Re: 7914 Monitor

Hi,

Actually you have to configure all things as per "FXS SCCP feature mode" document. I suggest you use a looback interface as "endpoint address" for this.

Thanks for the nice rating and good luck!

Hope this helps, please rate pots if it does!

New Member

Re: 7914 Monitor

Hi Paolo,

Sorry I don't get it. The only thing it says is enabled the "stcapp call-control mode feature"

Can you kindly provide some config example? Thank you!

Hall of Fame Super Gold

Re: 7914 Monitor

Rightly, you couldn't see the config examples from that document that is about the optional "feature mode" only.

Please refer to:

http://cisco.com/en/US/products/ps6441/products_feature_guide09186a0080483a76.html

for the "basic" config of sccp mode for fxs ports. I should have provided that link before, sorry for the confusion.

New Member

Re: 7914 Monitor

Thank you Paolo! I'll give it a go tomorrow as I am off today, and update "Resolved my issue" as needed.

New Member

Re: 7914 Monitor

Hi Paolo,

All is well! Thank you for all you help!!!

To add to this... I had to do a "sh ephone anl" to get the mac address. I let the CCME auto assign the MAC. There was no way I was going to tried to do the conversion.

139
Views
10
Helpful
7
Replies
CreatePlease to create content