Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7914 on 7960 - lights to show if ext is on the line

Running Call Manager Business Edition  7

We have 7960 phones with 7914 expansion units.

They have been setup with ext numbers and names but is there any way that we can get the buttons to light up when an ext is on the phone.

That way our receptionist can advise the caller that they will go to voicemail and can leave a message or they can call back

Thanks in advance

5 REPLIES

Re: 7914 on 7960 - lights to show if ext is on the line

Not with the 7914. The newer side cars / expansion modules do support buttons that light based on various parameters. For remote line in use, it glows red while the line is in use (for example). one such sidecar is the 7915. It is not compatible with the 7960 however.

Hth.

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Hall of Fame Super Red

Re: 7914 on 7960 - lights to show if ext is on the line

Hi Jenny,

Bill is probably right ...but I could have sworn

If these are "shared lines" that are on both the Primary user phones

and a button on the 7914 as well, they should light Red when then

user is on their appearance of the "shared line".

Have you tried changing the Privacy setting on the user's

phone configuration page?

Cheers!

Rob

New Member

Re: 7914 on 7960 - lights to show if ext is on the line

+5 to Rob you can get the lights to work if you set them up as shared lines.  This will give you the following information on the lights:

Lighted Buttons—14 buttons. Each button corresponds to one line (just like on the Cisco IP Phone). The lights beneath each button indicate the state of the corresponding line as follows:

Line available: light off

Line in use by you: steady green light

Line in use by someone else: steady red light

Line ringing: flashing amber light

You have a call on hold: flashing green light

Someone else has a call on hold: flashing red light

Call transfer: steady green light

From the 7914 guide:  http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/7914/4_1_3/english/user/guide/14qsbar.pdf

Re: 7914 on 7960 - lights to show if ext is on the line

Yes, +5 to Rob and Budmiller, -5 to me This is what happens when you trust my memory I suppose! Thanks Rob and Bud for coming in and setting me straight!

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Hall of Fame Super Red

Re: 7914 on 7960 - lights to show if ext is on the line

Hey Bud & Bill,

Thanks to both of you for weighing in on this +5 each my friends.

It's been awhile for me to setup this config so I was going to try it in the

lab later on. But now you've freed me up to do other tasks (which one of the

other 39,437 to do now ...hahahaha!!)

Bill ...no -5 for you buddy, you deserve +500 for all your hard work here!

Cheers!

Huff

417
Views
25
Helpful
5
Replies