Got a couple of the new expansion modules to test. Downloaded and installed the latest firmware 1.0(2)on my 6.1.1b lab system and restarted both the CCM and TFTP services. Neither module shows up under Device Defaults Configuration or Firmware Load Information and it can not be selected on a device as an expansion mod. Only the 7914 shows up. I can see the COP files under Software options Any ideas how to activate?
Currently i am facing lot of problem regarding this.
Running UCM 6.1.2.
7962 using fot auto attendent with 7915x2 expansion module. But 7962 is not able to detect 7915 modules. I tried to upgrade the firmawre from SCCP42.8-3-4SR1S to cmterm-7942_7962-sccp.8-3-5.cop.sgn, but it is not upgrading. I tried from Device configuraion and from TFTP defaults(after uploading new firmare)....but it's not happenning.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...