Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

7921 problem after upgrade to 1-3-3

Hello forum!

I am running CM 4.2(3) and after the firmware upgrade of the 7921 to 1-3-3 I have problems.

It registers normally but after some hour the message "NOT IN SERVICE" appears. Then it resets and the initial steps happen again:

1. Opening 172.16.x.x (cm ip)

2. Configuring IP

3. Confiruring CM List (somethimes it freezes)

4. Opening 172.16.x.x (again... and it freezes)

Any suggestions?

Firmware problem? Wireless problem?

Thanks in advance

1 REPLY
Community Member

Re: 7921 problem after upgrade to 1-3-3

We run 4.13SR8a and have hundreds of 7921s and a handful of 7925s with no problems that you are describing.

296
Views
0
Helpful
1
Replies
CreatePlease to create content