I have wireless phone 7925G with CME 8.6, the wireless phone is connected through wifi and I can reach it from the CME but the phone is not registering and shows the message "not in service", the Status message of the phone shows tftp timeout.
the TFTP configuration is:
tftp-server flash:CP7925G-1.4.2/APPSH-1.4.2.SBN alias APPSH-1.4.2.SBN
tftp-server flash:CP7925G-1.4.2/GUIH-1.4.2.SBN alias GUIH-1.4.2.SBN
tftp-server flash:CP7925G-1.4.2/SYSH-1.4.2.SBN alias SYSH-1.4.2.SBN
tftp-server flash:CP7925G-1.4.2/TNUXH-1.4.2.SBN alias TNUXH-1.4.2.SBN
tftp-server flash:CP7925G-1.4.2/WLANH-1.4.2.SBN alias WLANH-1.4.2.SBN
tftp-server flash:CP7925G-1.4.2/CP7925G-1.4.2.LOADS alias CP7925G-1.4.2.LOADS
and in the load is configured in the telephony service as follow:
load 7925 CP7925G-1.4.2.LOADS
debugging the TFTP doesn't show any result though there is no security applied to deny the TFTP traffic.
Hi, Check the DHCP option 150 in wireless lan. This option provides TFTP server ip to phones , the reason why you are not seeing any messages in debug tftp is because phone are not contacting the correct cme ip to get their configuration/load file.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...