I have a UC520 with two AIR-LAP521G access points controlled by a WLC526. I have two ssids created on the WLC526, one ssid pointed to the data vlan (1) and a voice ssid pointed to the voice vlan (100).
Devices associate fine to the data vlan.
However, I have a 7925G wireless phone that I cannot get to associate to the voice ssid.
I have configured the voice ssid in CCA as follows:
WLAN type: Voice
Broadcast in Beacon is checked
Security Type: WPA2-PSK
WPA Pre-shared key is set.
Voice CAC Type: (I have tried both options: Wireless Multimedia Policy and 7920 CAC)
I have confirmed that the voice vlan also exists under Switching > VLANs on all devices. I also confirmed that the WLC526 port is configured for trunking:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...