Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

7935-conference phone

Hi,

I have a 7935 conference phone registered with my call manager 5.3 version. It is working fine for the past 1 year. Suddenly it got disconnected from my controller and the ip phone keeps on rebooting. The dhcp address given to the voice network is 172.16.x.x but I can find (in call manager) the 7935 getting ip address 10.4.X.X.which is no where (dhcp) in my network. I am not able to add ip address manually. The 7935 is not able to take manually configuration, it is kept on rebooting. I can find in the display obtaining ip address…and then it reboot with a sound. Even I tried it by connecting in different ports.

please help...

9 REPLIES
Hall of Fame Super Red

Re: 7935-conference phone

Hi Satya,

This is a known issue with the Cisco 793x Conference phones. The clip below references the problem and fix;

The 7935 IP Conference Phone Receives Data IP Address Instead of Voice IP Address

If the 7935 IP Conference Phone is connected to a switch, the conference phone receives the IP address from the data VLAN. If the 7960 IP Phone is connected on the same switch port as the 7935 IP Conference Phone, the 7960 receives the IP address on the voice VLAN.

This issue is due to the design of the 7935 IP Conference Phones. This conference phone does not have a 10/100 port to connect a PC like other 7900 Series IP Phones have. The concept of voice VLAN or auxiliary VLAN does not directly apply to the 7935 IP Conference Phones

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_configuration_example09186a0080722cdb.shtml#ts2

7935 IP Conference Phone Optimal Performance Configuration

http://www.cisco.com/en/US/products/hw/phones/ps379/products_tech_note09186a00802381ab.shtml

Hope this helps!

Rob

Community Member

Re: 7935-conference phone

Sounds like you have a rogue DHCP server somewhere. I suggest using a sniffer and taking a look.

Randall

Community Member

Re: 7935-conference phone

Hi,

I don't have any dhcp servers with in my network.

Community Member

Re: 7935-conference phone

Hi,

i am not using a poe switch.7935 is connected by using a power adaptor.If i connect to poe switch 7935 is not getting power.I heard that 7935 phone will have different cables(stright/patch cards)to connect,is it?

Community Member

Re: 7935-conference phone

Hi,

please heip in this reg...please...

Community Member

Re: 7935-conference phone

Hi,

please....

Hall of Fame Super Red

Re: 7935-conference phone

Hi Satya,

You are right using the power cube that is supplied with the 7935 :) There are no PoE Switches that can supply enough power for the 7935 or 7936 phones. I would have a look at your switchport config. Because the 7935 does not recognize the Voice Vlan command you must use;

switchport mode access

switchport access vlan xxx (where xxx is your voice vlan)

Hope this helps!

Rob

Community Member

Re: 7935-conference phone

Hi Rob,

I already done this but,no result.Do you think my FIRMWARE was gone....

thanks..

Regards,

Satya.M

Community Member

Re: 7935-conference phone

hi,

please reply..

1236
Views
0
Helpful
9
Replies
CreatePlease to create content