Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

7940 phones handset does not work unless headset button is pressed

have a handful of 7940 phones when you pickup the handset there is no dial tone unless you hit the headset button then it gets a dial tone. Any ideas what can be causing this?

2 REPLIES
Gold

Re: 7940 phones handset does not work unless headset button is p

Handset and Headset button are independant of each other. Only reason that I know of why this could happen is if the cable from the handset is connected to the headset port and not handset on the phone. The Handset button is at the button and the headset on top.

If this connection is right, then you might want to open a TAC case for them to troubleshoot the issue and if needed RMA the phones

Hall of Fame Super Red

Re: 7940 phones handset does not work unless headset button is p

Hi Tom,

Just to add a note to Mahesh's good info (5 points for always helpful posts Mahesh :). I'm 99% sure its RMA time for these 7940's.This is most likely a problem with the Hookswitch. After deploying Cisco IP Phones for the last few years we (and many others) have found this to be the most common hardware problem. There is a "Best Practice" for cleaning the Hookswitch contacts (link below) that does work on occasion. Usually the phone has to be replaced/RMA'd.

Best?? Practices for Cleaning and Troubleshooting Cisco IP Phone Hookswitch

From this interesting Tech note;

http://www.cisco.com/en/US/products/hw/phones/ps379/products_tech_note09186a00801c0810.shtml

There was also a problem with the 7.2 phone firmware that caused similar looking symptoms but I am pretty sure that it was for the 3rd generation phones 7970/7961/7941. This could be rectified in the short term by booting the phone.

Hope this helps!

Rob

4329
Views
5
Helpful
2
Replies