Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

7940 sccp to sip

Hi All

I need to convert an existing 7940 running sccp on my cme 4 system to sip.

I have downloaded sip firmware, used tftp-server command to share files.

Then created voice register pool and dn commands to setup the phone.

I've setup voice register global with phone load command and used upgrade and create profile commands.

Problem is it always reverts to sccp.

I used show telephony-service tftp-bindings to view config files and don't see ANY sip config files.

I think there should be a sipdefault.cnf file along with others? is this correct? if so where do i get them from?

Thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: 7940 sccp to sip

You see the sip files with show voice register global tftp-bindings.

Remember to remove the ephone for the corresponding phone also.

The best way to change load is to factory reset the phone (I think you know the sequence by now).

3 REPLIES
Hall of Fame Super Gold

Re: 7940 sccp to sip

You see the sip files with show voice register global tftp-bindings.

Remember to remove the ephone for the corresponding phone also.

The best way to change load is to factory reset the phone (I think you know the sequence by now).

New Member

Re: 7940 sccp to sip

Once again you come to my rescue!

The 'show voice register global tftp-bindings' command didn't work so I couldn't the bindings.

But I tried a factory reset and for some unknown reason it worked!

I'd still like to understand why it didn't do it before but hey - result!

Thanks

Hall of Fame Super Gold

Re: 7940 sccp to sip

Sorry, that is,

show voice register tftp-bind

Happy it helped. good luck!

139
Views
0
Helpful
3
Replies
CreatePlease to create content