I have about 30 newly installed 7940G phones in my company. Most of these display the "more" softkey but a few do not. All phones appear to have the same firmware version 7.2(T0.23). How do I enable "more" on the 7940G?
If the Softkey template of the phones without the MORE softkey does not have more than 4 options selected for each state then you will NOT get the MORE softkey. Go to that Softkey template as Zin told you and go to configure softkey layout and see what options do you have for the Template that the phones are using.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.