In the past month I have had about 20 phones have QOS issues. If I browse to the IP address of the phone I notice a lot of jitter and Recr Discard entries sometimes I can hard reset the phone and the problem clears up, but most of the time I have to setup a new phone and call the old one defective. The MOS score will drop to 2.0-2.5. Could there be something else going on besides a defective phone? Any input would be great.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.