Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7941 Phone cycles through upgrading then reboots

One of our customers inherited a handful of Cisco 7941 phones and want to see if they can incorporate them into a hosted (non cisco) platform. The hosted service provider says the phones will need to be configured manually. The problem is on our test phone, we've reset to factory default, but the phone simply boots up, shows the splash, then the term "upgrading" and the mac address is listed, and the phone reboots. Then it starts all over. It there a way to manually stop this upgrade process so that I can enter the settings into the phone? Any other suggestions?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: 7941 Phone cycles through upgrading then reboots

When you factory reset the phone, you erased the firmware from it. Now, you must obtain the firmware files and load them on a tftp server in order for the phone to access them.

1 REPLY
Hall of Fame Super Gold

Re: 7941 Phone cycles through upgrading then reboots

When you factory reset the phone, you erased the firmware from it. Now, you must obtain the firmware files and load them on a tftp server in order for the phone to access them.

162
Views
0
Helpful
1
Replies