I have a bunch of 7941's running off a 2811/CME combo. I've got it all working nicely, but something that's been bugging my users is the placed calls.
Right now, when you navigate to the placed calls directory, all the entries are "Unknown Number"(unless it's an internal extension, or a number in one of the set directories), if i hit dial, i just get a dialtone, if i hit details, all i see is a blank To: line.
If there something i need to do to allow the phone to save the numbers it's dialled?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...