Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7945/65 conference noise on line

Hi,

We have deployed CUCM version 6.1.2.1002-1 and have a mixture of 7945 & 65 through out the campus. When you call IP to IP it use G722 and the quality is fine, when add a conf call it converts it to G711 and then start to get noise in the ear piece of all phones involved.

CUCM is running - 6.1.2.1002-1

45 & 65 are - SCCP45.8-3-4SR1S

All the media resources are configured on CUCM.

I have disabled the Advertise G722 codec type, but this has made no difference to the quality of the call.

Has any one else experienced anything similar?

Regards,

James

2 REPLIES

Re: 7945/65 conference noise on line

What does the processor utilization look like on the CUCM server when you are conferencing? If the CUCM is providing the conferencing resources, emulating those DSP resources in software will put a heavier load on the server.

Do you have any spare DSP resources on the VG that you could use to at least test a IOS-based Conference resource?

VIP Super Bronze

Re: 7945/65 conference noise on line

Try newer firmware on the phones. There were a lot of bugs surrounding sound quality in the initial releases for the 79x5 phones.

Please remember to rate helpful responses and identify helpful or
130
Views
0
Helpful
2
Replies