Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7960 Phone

I bought 4 of these phones. and i can't get them to reset back to factory or anything actully.

They bootup with APplication Loader. it goes through Configure Vlan,Ip,Request Config, couple there things. and then trys to open up couple IP's.

I would like to set these all back to defualts. so i can flash them to use on SIP. I have tried few ways to reset them. But nothing matches what the sites say to what i have. i was able to hold down # on bootup and it said Reset key seq. and then went on to booting up again.

1 REPLY
Hall of Fame Super Gold

Re: 7960 Phone

This is a FAQ.

When it says reset seq, type 012345678#*0

Note you need the firmware files and tftp server, otherwise phones will remail unusable.

110
Views
0
Helpful
1
Replies