I have a 7961 phone with the following loads: SCCP41.9-0-3S.
I want to install the phone with a customer who has CME but with a lower loads file: SCCP41.8-3-2S.loads
Will this cause any issues?
Initially the phone didn't boot at all, so i connected it to my computer and gave it firmware with a TFTP client, then i hanged it on the company's network and it recieved a total newer firmware version.
I did have to solve this differently. The phone didn't respond anymore after a factory reset. So i did a hard reset and plugged the phone to my computer and uploaded the required firmware files via TFTP.
So the phone is now just running the firmware that is present in the CME onsite.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.