i'm installing CCME with ios 15.0(1r)M16 and with CME version 9.1, i'm trying toconfigure a 7962 telephone, intially i've decompressed to the router the firmware for this telephone and configured the tftp server, when the telephone starts it doesn't update the firmware to my version (9.2.1), the telephone brings the version 220.127.116.11, so i thinked that the problem is the version from the phone is newer than mine version, so i've made a soft factory reset, after tis i saw the telephone doanloading the first file from the firmware but never updates, so i've installed in the CME a older version (8.3.3.S) the problem persists, and i've done a hard factory reset, and now the telephone stils with the same problem and never updates de the firmware i've the follwing files in flash:
extracting apps42.8-3-2-27.sbn (2496963 bytes)
extracting cnu42.8-3-2-27.sbn (585562 bytes)
extracting cvm42sccp.8-3-2-27.sbn (2452185 bytes)
extracting dsp42.8-3-2-27.sbn (326315 bytes)
extracting jar42sccp.8-3-2-27.sbn (443607 bytes)
extracting SCCP42.8-3-3S.loads (658 bytes)
extracting term42.default.loads (662 bytes)
extracting term62.default.loads (662 bytes)
and the follwing tftp server commands:
in telephony service i've configured the load command like that:
load 7962 term62.default
The output of debug tftp evensts is like that:
Dec 9 22:19:51.091: TFTP: Looking for term62.default.loads
Dec 9 22:19:51.095: TFTP: Opened flash0:term62.default.loads, fd 9, size 662 for process 377
Dec 9 22:19:51.095: TFTP: Finished flash0:term62.default.loads, time 00:00:00 for process 377
Anyone have a clue about this problem and how can i install a firmware in this telephone?
These must be new phones with new hardware revision which do not support anything below 9.3.1, so the downgrade will not work. This was asked here few times in the last few months, your only option is to keep the current version or install newer one. Why would you want to go down to 8.3.3 makes no sense, remember phone firmwares are independent of CME version and you can upgrade them to whatever you choose.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...