They are in the Media Resources configuration of the CUCM Admin page. Ideally, you define your software and hardware resources (preferring hardware resources where available). In most cases, you should have a CFB, ANN (Annunciator), MTP (Media Termination Point), and etc. defined - there may be multiple of each depending on how many servers or hardware resources you have to provide those functions. Those resources are then assigned to Media Resource Groups (MRG) which are assigned in priority order with Media Resource Group Lists (MRGL). The MRGL is then assigned to the Device Pool to which phones are assigned.
I have a similar issue. In the MRGL, I have listed the MRG for the local router, which only has the XCODE resource in it, followed by another MRG, which contains the two CFB resources. Would the order of the MRGs have anything to do with this problem, or is it immaterial since at least one of the MRGs contains the CFB resources? Thanks.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...