I have a customer who is experiencing what appears to be a cosmetic error on their 7965s. When deploying endpoints into the field they have found that if they hard code the speed/duplex to 100/Full on the PC port of the phone they get a "Port Configuration Error". The funny thing is that the PC appears to function normally at 100 Full. When I change the endpoint to auto-negotiate from CUCM the error goes away.
No worries, how about the actual switch port on the phone? Are both the PC and SW ports set to Auto or 100 Full? I would still be curious about what the network port on the switch is set to as well. I am running 7965G's in both SCCP and SIP form and no matter how I have the ports set and cannot recreate. I am also running 9.3.1sr2 firmware on both.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.