Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7965G "Display on time" CUCME

Is there a way to configure the "Display on time" and "Display on duration" settings in CUCM Express? I can not change the settings from the phone display, nor can I find any CLI reference.

Thank you in advance for your help.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: 7965G "Display on time" CUCME

Hi Jack,

These settings are found here;

service phone

To modify the vendorConfig parameters in the configuration file, use the service phone command in telephony-service or ephone-template configuration mode. To disable a setting, use the no form of this command.

service phone parameter-name parameter-value

no service phone parameter-name parameter-value

For example

displayOnTime HH:MM

Sets the time of day at which IP phone displays are activated, using a 24-hour time format.

•Hour (HH) and minute (MM). You must enter all four characters. For example, 9:05 a.m. must be entered as 09:05. Default is 07:30.

Note This parameter is not supported in ephone-template configuration mode.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_s1ht.html#wp1092998

Hope this helps!

Rob

1 REPLY
Hall of Fame Super Red

Re: 7965G "Display on time" CUCME

Hi Jack,

These settings are found here;

service phone

To modify the vendorConfig parameters in the configuration file, use the service phone command in telephony-service or ephone-template configuration mode. To disable a setting, use the no form of this command.

service phone parameter-name parameter-value

no service phone parameter-name parameter-value

For example

displayOnTime HH:MM

Sets the time of day at which IP phone displays are activated, using a 24-hour time format.

•Hour (HH) and minute (MM). You must enter all four characters. For example, 9:05 a.m. must be entered as 09:05. Default is 07:30.

Note This parameter is not supported in ephone-template configuration mode.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_s1ht.html#wp1092998

Hope this helps!

Rob

283
Views
0
Helpful
1
Replies
CreatePlease login to create content