I have UC540 and trying to get 7970 phone to work via SIP.
SIP trunk is registered... I've included snippet of configs. The phone upgraded SIP firmware with no problems but once it's booted up it continues to go from 'Updating Locale' to 'Unprovisioned' and keeps cycling through that. Any suggestions would be greatly appreciated as I'm stuck.
Hello guys. I have the same problem with my Cisco 7970G IP phone which I'm trying to configure to work via SIP. Below is the part of my config:
tftp-server flash:/7970/SIP/apps70.9-4-2ES9.sbn alias apps70.9-4-2ES9.sbn tftp-server flash:/7970/SIP/cnu70.9-4-2ES9.sbn alias cnu70.9-4-2ES9.sbn tftp-server flash:/7970/SIP/cvm70sip.9-4-2ES9.sbn alias cvm70sip.9-4-2ES9.sbn tftp-server flash:/7970/SIP/dsp70.9-4-2ES9.sbn alias dsp70.9-4-2ES9.sbn tftp-server flash:/7970/SIP/jar70sip.9-4-2ES9.sbn alias jar70sip.9-4-2ES9.sbn tftp-server flash:/7970/SIP/SIP70.9-4-2SR1-1S.loads alias SIP70.9-4-2SR1-1S.loads tftp-server flash:/7970/SIP/term70.default.loads alias term70.default.loads tftp-server flash:/7970/SIP/term71.default.loads alias term71.default.loads ! voice service voip allow-connections sip to sip fax protocol cisco sip registrar server ! voice register global mode cme source-address 22.214.171.124 port 5060 max-dn 10 max-pool 5 load 7970 SIP70.9-4-2SR1-1s tftp-path flash: create profile sync 0078327219347302 ! voice register dn 1 number 3002 ! voice register pool 1 id mac 001F.9E26.4B8B number 1 dn 1 codec g711ulaw
The 1st problem is that phone is stuck with UNPROVISIONED error.
The 2nd problem is that after erasing config section for SIP and entering lines for SCCP aliases I get the error (on screenshots).
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...