Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7975 spare install

I am replacing my 7941 with a 7975 spare. i am not getting any power on new 7975 and i am using the same port i use for the 7941. any suggestions

2 REPLIES
Hall of Fame Super Red

Re: 7975 spare install

Hi James,

You may be running into a PoE problem here, depending on what type of switch/switchport is being used. If you are using an older model that only supplies Cisco Pre-Standard PoE it won't fire up the 7975G :(

The 7941G can use either Cisco Pre-Standard PoE or the new standard IEEE 802.3af PoE.

Power Requirements:

The phone is interoperable with Cisco Pre-standard PoE and with IEEE 802.3af PoE (the phone is a Class 2 device); 48 VDC is required; it can be supplied locally at the desktop using an optional AC-to-DC power supply (part number CP-PWR-CUBE-3=).

From this good doc;

http://www.cisco.com/en/US/products/hw/phones/ps379/products_data_sheet0900aecd802ff012.html

The 7975G can only use IEEE 802.3af PoE

Power Requirements:

Supports IEEE 802.3af PoE (Class 3). 48VDC is required; it can be supplied locally at the desktop using an optional AC-to-DC power supply (part number CP-PWR-CUBE-3=) or power injector (CP-PWR-INJ=). Local power options require a corresponding AC country cord

http://www.cisco.com/en/US/products/hw/phones/ps379/products_data_sheet0900aecd8069bdb7.html

Hope this helps!

Rob

New Member

Re: 7975 spare install

Yes you'll need an IEEE 802.3af compliant PoE source to power your Cisco 7975G

312
Views
0
Helpful
2
Replies
CreatePlease login to create content