Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

8 out of 10 phones will not Power up after switch to UPS power.

We had a brief power loss this morning, switch is on UPS. After this event, switch will boot fine but only two of the phones will connect and power up. All other phones show down down on the switch and will not power up at all. Has anyone seen this issue before? How do you fix it?

2 REPLIES
New Member

Re: 8 out of 10 phones will not Power up after switch to UPS pow

POST: Inline Power Controller Tests : Begin

POST: Inline Power Controller Tests : End, Status Failed

I called TAC. We are replacing the switch.

Re: 8 out of 10 phones will not Power up after switch to UPS pow

yep, that's hardware failure which needs a replacement.

Good luck with next power failure :)

119
Views
0
Helpful
2
Replies
CreatePlease to create content