Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

8021.q trunk on switch port

hi...how ip phone make trunk with switch port? does the switch at least need dynamic mode(auto,desirable,...). some doc said that we dont need explicitly configure switchport to be trunk.. does it mean dynamic port(auto,desirable,..) is enough which is enabled by default from factory? tx

1 REPLY
Hall of Fame Super Gold

Re: 8021.q trunk on switch port

Yes default is enough. Then add "switchport voice vlan XX" and you are all set.

Hope this helps, please rate post if it does!

233
Views
0
Helpful
1
Replies