Is it possible to use one of the softkeys on a 8945 a button for DID, instead of using one of the PLKs?
I know this is not possible on the 99xx series because they are SIP based, but I figured since the 8945s are SCCP, it would be possible to use a DID key just like a 79xx phone. I have specified a softkey template that has the DID key in it, but when applied to the phone, it does not show up.
I think I am using the latest - 9.1.2(SCCP 9-1-2-00).
I'm not even sure if what I am looking to do is intended to be possible. I was simply hoping for it, because I would like to reserve the PLKs for actual lines, rather than feature buttons, when the bottom softkeys should, in my opinion, be available for them.
Yeah, that's what I was afraid of. Not a big deal, but it would be nice if I could use all 4 line buttons as, you know, actual line and coverage assignments, instead of dedicating them to features, when there is a perfectly free softkey on the bottom of the screen!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...