Hi, I just put a 9-Port HWIC-ESW Power Daughter Card in our 2821 router and have configured the ports for the appropriate voice and data vlans. Data connectivity is working fine however the phone is dead in the water (no power). The show diag has this listed as a 9-Port HWIC-ESW Power Daughter Card so I am assuming this should be POE. Is there any special commands needed to get power or anything I can check to see why this is not working.
I had meet a situation with the same card in which I had to configure "switchport mode trunk" to make it work, as opposed to switches where "mode access" is correct. Maybe let us know if it's the same for you.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.